ASA filament
Summary¶
ASA (Acrylonitrile Styrene Acrylate) is a UV- and weather-resistant thermoplastic with mechanical properties close to ABS but markedly better outdoor durability. In the libdrone context it is a candidate material for printed parts exposed to prolonged sunlight, where PETG and PETG-CF can soften or degrade over time. It prints harder than PETG — it warps, needs an enclosure, and releases styrene fumes that require ventilation — so it is chosen only where outdoor longevity justifies the added process difficulty.
Concept¶
ASA is a styrenic terpolymer: the acrylate rubber phase that replaces ABS's butadiene is what gives it its defining property — resistance to UV degradation and yellowing. Where ABS chalks and embrittles after months of sun exposure, and where PETG slowly loses dimensional stability under combined UV and heat, ASA holds its colour, surface, and mechanical properties outdoors for years.
Mechanically it is comparable to ABS: a glass transition around 100 °C, good impact strength and stiffness, and ductile rather than brittle failure. The trade-offs are all in processing. ASA has a high coefficient of thermal expansion, so it warps and can delaminate without a heated, draught-free enclosure. It emits styrene during printing and must be run with ventilation or filtration. It is more hygroscopic than PLA and benefits from dry storage.
Against the other libdrone materials: PETG-CF is the structural default — stiff, abrasion-resistant, easy to print, but not selected for long-term UV service. PCCF (polycarbonate-carbon fibre) is for high-temperature, high-load structural parts. ASA occupies a narrow niche between them: parts that are not primarily structural but must survive sustained outdoor exposure.
Reference¶
The values below are generic starting points drawn from common ASA filament datasheets, not libdrone-validated print settings. Treat them as a baseline to dial in against your own printer, enclosure, and the specific part.
| Parameter | Generic starting range |
|---|---|
| Nozzle temperature | 240–260 °C |
| Bed temperature | 90–110 °C |
| Enclosure | Required (passive enclosure minimum) |
| Chamber draughts | Eliminate — warping and layer splitting otherwise |
| Ventilation | Required — styrene emission during printing |
| Bed adhesion | Glue stick or ABS/ASA slurry; brim on tall parts |
| Cooling fan | Low or off — aggressive cooling causes delamination |
| Storage | Dry; mildly hygroscopic |
| Nozzle | Standard 0.4 mm brass acceptable (non-abrasive) |
Procedure¶
Rationale¶
ASA earns a place in the corpus for one reason: outdoor UV survivability. Any libdrone part that sits in direct sun for extended periods — and that is not carrying primary structural load — is a candidate to move from PETG-CF to ASA, because PETG's long-term behaviour under combined UV and thermal load is the weak point ASA is specifically formulated to address.
Which libdrone parts, if any, should actually be printed in ASA is a decision that is deliberately left open here. The corpus principle is that material choices are validated by real build and field experience, not asserted from datasheets. ASA's added process difficulty — enclosure, ventilation, warping — is a real cost, and committing a part to ASA should follow a printed-and-tested coupon, not a specification written in advance. This atom is therefore marked draft: it captures why ASA exists in the material set and how to print it generically, and defers the libdrone-specific part assignments and validated profiles to build experience.
Connections¶
requires: - material-selection-philosophy related: - petg - pccf - print-profiles leads_to: - print-profiles